Adhesives & Sealants
 
RTV-1 & RTV-2
Agriculture Advajunts
Artificial Marble / Quartz
Building Protection
Coatings & Paints
Contact Lenses
Dental Surgery
Diffusion Pump Fluid
Electronics
Fillers & Pigments
Foundry Investment Casting
Foundry Resins
Glass Fiber
Li-ion Batteries
Oilfield
Olefin Polymerisation
Personal Care
Pharmaceuticals
Photovolatics (Solar Cells)
Plastics & Thermoplastics
Polyurethane Foam
Rubber & Tyre
Silicone Rubber
 
Condensation Cure
Addition Cure
Heat Cure Elastomer
Sol-gel Coating
Textile Finishes
Thermosets



Silanes & Silicones for Adhesives & Sealants
  Silane as Adhesion Promoter Silane as Crosslinkers
  Silane as Water Scavengers Silane Coupling Agents
  Fumed Silica Silane Terminated Polymer (STP)

Silane as Adhesion Promoter

SiSiB® silane adhesion promoters are bifunctional organosilicone compounds which act as molecular bridges between the polymer matrix of an adhesive or sealant and the substrate, either inorganic or organic. SiSiB® SILANES can improve adhesive or sealant adhesion significantly. SiSiB® SILANES react chemically and promote adhesion: (1) between the base polymer in a sealant and the inorganic fillers in the formulation and / or (2) between the base polymer and the substrate.
 
The silane end contains hydrolysable alkoxy groups that are activated by reaction with ambient moisture. The hydrolysable alkoxy groups attached to the silicon end of the silane are typically either methoxy or ethoxy. Once activated (hydrolyzed), the resultant silanol groups will condense with other silanols or with reactive groups on the surface of a substrate such as SiOH, AIOH, or other metal oxides or hydroxides.The silane’s ability to bond to a surface will generally be determined by the concentration of such sites on the surface.

Selecting the optimal silane for an application requires matching the reactivity of the silane‘s organofunctional group to that of the polymer.
The silanes can be blended into an adhesive formulation or used as primers on substrates. The structure and reactivity of the silane will affect the ability of the silane to migrate. The most effective way to promote adhesion is to apply the silane as a primer to the surface, followed by application of the adhesive/sealant. In this way, the silane will be on the surface and therefore at the interface where it can enhance adhesion between the polymer and the substrate. Silane primers are usually dilute solutions of 0.5 to 5 percent silane in alcohol or water/alcohol solvent. They are wiped or sprayed on the substrate, after which the solvent is allowed to evaporate. While the concentration needed for a specific application may vary, one percent (1%) based on resin content is recommended as a good starting point.


SiSiB® SILANES 2016 SiSiB® SILICONES 2016
SiSiB® FUMED SILICA SiSiB® SILICONE RUBBER 2016
SiSiB® Silicones for Textile SiSiB® SILANE DONORS
SiSiB® Silicones Water Repellents SiSiB® Silicones for Personal Care
SiSiB® Silicone PU Additives SiSiB® Silicone Coating Additives
SiSiB® Silicone Masterbatch for Plastic SiSiB® STP (Silane Terminated Polymer)
SiSiB® Silane Crosslinkers SiSiB® Silane Coupling Agents